Removing The Intel Raid Smart Battery; Replacing The Power Supply; Figure 60. Removing The Intel ® Raid Smart Battery; Figure 61. Removing The Filler Panel - Intel Server System R1000GZ Service Manual

Hardware Installations and Upgrades
Removing the Intel
1. Slide the plastic battery holder toward the front of the system to disengage it from the BBU
bracket (see letter "A").
2. Lift the battery up to remove it from the server chassis (see letter "B").

Replacing the Power Supply

Caution: The power supply is only hot-swappable if you have a redundant system with two power
supplies installed. If you only have one power supply installed, before removing or replacing the
power supply, you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power cord from the
system or wall outlet.
The power supply can be replaced if it fails. To replace the power supply, follow these steps:
1. Do one of the following:
- If a filler panel is installed, use the 'finger hole' to remove the filler panel (see letter "A").
- If a power supply is installed, push the green latch in the direction shown while pulling out
of the system by the handle.
36
®
RAID Smart Battery
Figure 60. Removing the Intel

Figure 61. Removing the filler panel

®
RAID Smart Battery
®®
Intel Server System R1000GZ/GL Service Guide