Table of Contents
Advertisement
P rismPlus! Printer
2 6 B
@
Required Tools:
·
Torx T25 screwdriver
·
5/32" Allen wrench
1.
Power on the AutoPrinter.
&
Tip: If the Prism power switch is in the On position, you can power on both the printer and the
AutoPrinter by pressing the AutoPrinter power switch.
2.
Wait for the system to complete initialization.
3.
Prepare the system for alignment.
a.
Manually slide the lift arm to the top of the
AutoPrinter.
b.
Place a disc on the lift arm by pressing the
disc into the gripper while pressing the
disc release button.
c.
Release the disc release button. The
gripper holds the disc.
d.
Press the printer operator button to open
the printer tray.
4.
Align the printer.
a.
Slowly slide the lift arm
down until the disc just
touches the print pad.
110656_L
Maintain the AutoPrinter
Printer
Operator
Button
Side-to-Side
Alignment
Print
Pad
Gripper
Disc Release Button
Holding Pins
Lift
Arm
Lift
Arm
Disc
13
Advertisement
Table of Contents
