Rimage Everest Setup And Installation

Rimage AutoEverest
1
Unpack the Everest printer.
To unpack the Everest printer, refer to the Everest Unpacking
and Setup Instructions included with your Everest printer.
2
Install the Everest printer.
Place the Everest printer on
the AutoPrinter so the plastic
feet slide into the slots on the
printer plate.
3

Connect the cables.

a. Connect the printer
cable from the
AutoPrinter to the
Everest printer.
b. Connect the short
power cord from
the AutoPrinter
to the Everest
printer.
c. Connect the
power cord from
the AutoPrinter to a
power outlet.
1

Setup and Installation

™
Printer plate
Slots for feet
d. Connect the USB
cable from the
Everest printer to
the computer.
4

Install the printer driver.

For detailed instructions, refer to the Everest Printer User Guide.
5
Install the CD Designer Software Suite.

Important! CD Designer is not Macintosh
This step applies only if you are installing the
AutoEverest on a Windows-based PC.
With the CD Designer Software Suite disc in the PC disc drive,
navigate to Setup.exe and follow the prompts to install the
software.
®
compatible.
110660_D