Sanyo PLC-HP7000L Owner's Manual page 75

This projector uses a high-pressure lamp which must be handled carefully and properly.
Improper handling may result in accidents, injury, or create a fire hazard.
● Lamp lifetime may differ from lamp to lamp and according to the environment of use. There
is no guarantee of the same lifetime for each lamp. Some lamps may fail or terminate their
lifetime in a shorter period of time than other similar lamps.
● If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE
indicator lights up, replace the lamp with a new one IMMEDIATELY after the projector has
cooled down. (Follow carefully the instructions in the Lamp Replacement section of this
manual.) Continuous use of the lamp with the LAMP REPLACE indicator lighted may increase
the risk of lamp explosion.
● Lamp may explode as a result of vibration, shock or degradation as a result of hours of use
as its lifetime draws to an end. Risk of explosion may differ according to the environment or
conditions in which the projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETy PRECAUTIONS SHOULD BE TAKEN .
If a lamp explodes, disconnect the projector's AC plug from the AC outlet immediately. Contact
an authorized service center for a checkup of the unit and replacement of the lamp. Additionally,
check carefully to ensure that there are no broken shards or pieces of glass around the projector
or coming out from the cooling air circulation holes. Any broken shards found should be cleaned
up carefully. No one should check the inside of the projector except those who are authorized
trained technicians and who are familiar with projector service. Inappropriate attempts to service
the unit by anyone, especially those who are not appropriately trained to do so, may result in an
accident or injury caused by pieces of broken glass.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering, give the following
information to the dealer.
● Model No . of your projector
● Replacement Lamp Type No .
LAMP HANDLING PRECAUTIONS
: PLC-HP7000L
: POA-LMP149
(Service Parts No.610 357 0464)
Maintenance and Care
75