Sanyo PLC-HP7000L Owner's Manual page 63

Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready 1 ........... When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the side control or remote control is
pressed.
Ready 2 ........... When 3 hours have elapsed since power
management has been carried out, the
lamp will turn off and the power will switch
off. The operations during the initial 3
hours are the same as for Ready 1.
Shut down ...... When the lamp has been fully cooled
down, the power will be turned off.
Off ................... Power management function is off.
Timer ............... If the input signal is interrupted and
no button is pressed for more than 30
seconds, the timer display with No signal
appears. It starts the countdown until the
lamp is turned off. Use the Point ▲▼
buttons to set the Timer (1~30 Min).
Note:
• Factory default is OFF: 5 Min.
• W hen the shutter is closed while the Power management
function is working, the Power management function is
released.
Direct on
When this function is set to On, the projector will be
automatically turned on just by connecting the AC power
cord to the wall outlet.
Note:
Be sure to turn off the projector properly (see "Turning
Off the Projector" on page 24). If the projector is turned
off in the incorrect sequence, the Direct on function
does not work properly.
Power management
Timer left before Lamp is off.
Setting
63