Table of Contents
Advertisement
Fitting the stability bracket or
chain
Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig. 9.7, Fig. 9.8,
Fig. 9.9 and Fig. 9.10.
If you are using a stability chain (Fig. 9.7) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket; first attach the bracket
location device to the rear of the cooker (Fig. 9.8). Then
adjust the bracket to engage through the slot of the device
(Fig. 9.9 and Fig. 9.10).
Repositioning the cooker following
connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig. 9.6), you need to check behind the cooker to make sure
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
With a stability chain fitted, release it as you ease the cooker
out. DO NOT forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
INSTALLATION
Check the appliance is electrically safe when you have finished.
Stability chain
Alternative positions
for stability location
bracket
Stability bracket
Stability
bracket
Wall
29
Cooker
Stability
location
bracket
Floor
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
Cooker
Stability
location
bracket
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical wall mounting
Fig. 9.7
Fig. 9.8
Fig. 9.9
Fig. 9.10
Floor
Advertisement
Table of Contents
