Table of Contents
Advertisement
Positioning the Range
Fig. 9.1, Fig. 9.2 and Fig. 9.3 show the minimum
recommended distance from the range to nearby surfaces.
The appliance should not be placed on a base.
Above hotplate surround should be level with, or above, any
adjacent work surface.
Fig. 9.2 Cookers installed into recess: The cooker must have
side clearance ABOVE hob level of 75mm up to a height of
410mm. This can be reduced to 25mm if the surface is made
from a non-combustible material.
A minimum space of 650 mm is required between the top of
the hob and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer's instructions.
**Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for
the additional height of the flue trim, which is fitted to the
range hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot
accept responsibility for damage caused by normal use of
the range to any material that de-laminates or discolours at
temperatures less than 65 °C above room temperature.
If the range is near a corner of the kitchen, a clearance of
130 mm is required to allow the oven doors to open (Fig. 9.3).
The actual opening of the doors is slightly less, but this allows
for some protection of your hand as you open the door.
When Fitting Between Kitchen Cabinets
We recommend that you either:
A.
Fit the range so that any cabinet doors are at least
30 mm behind the range door fronts. Note that this may
require an infill piece behind the range. We recommend
a gap of 1102 mm between units to allow for moving
the range. DO NOT box the range in – it must be
possible to move the range in and out for cleaning and
servicing.
B.
Leave a gap of at least 9mm on either side of the range
(a 1110 mm gap between units). The range should be
positioned centrally.
We also recommend that you DO NOT final fix any adjacent
cabinets until the range is installed. Decorative mouldings or
handles on cabinet doors and fronts may interfere with the
opening of the oven doors.
INSTALLATION
Check the appliance is electrically safe when you have finished.
WORKTOP
DOOR CHROME TRIM
DOOR HANDLE
Wall
410 mm min
Height to Hotplate
910 mm min
935 mm max
*See note
27
0
0
0
0
0
0
0
0
0
1
1
2
2
3
3
*Note
5mm gap if the appliance is 30mm in front of the
kitchen cabinets
9mm gap if the appliance is to be flush fitted
between kitchen cabinets
check cookerhood instructions for actual dimensions
1102 mm min
650 mm min
1092 mm
Height to Flue Trim
925 mm min
950 mm max
ArtNo.110-0004 - 110 Cooker min spacings
*Note
5mm gap if the appliance is 30mm in front of the kitchen cabinets
9mm gap if the appliance is to be ush tted between kitchen cabinets
130 mm minimum
Fig. 9.1
0
Fig. 9.2
Wall
410 mm min
*See note
Fig. 9.3
Advertisement
Table of Contents
