Table of Contents
Advertisement
4-14
10. Touch the Flow Control setting and select Xon/Xoff, hardware or none.
11. Touch the Operation Mode setting and select Disabled, DS-7000 Deck
Box Emulation or CLAM Shell pass-through.
12. Touch the check mark to close the COM2 Configuration pop-up and
save the COM2 serial port settings.
13. Touch Exit to close the Display screen.
Selecting the Beep and Units Preferences
The UDB-9000 provides an audible beep when touching a control or when an
error occurs. Both the control and error beeps can be individually enabled or
disabled. In addition, meters or feet can be selected for the displayed ranges.
To select the beep and units preferences:
1. Touch the Display function button.
The Display screen opens.
2. When touch beeps is on, the Touch beeps button indicates Touch Beeps
on. When touch beeps is off, it indicates Touch beeps off. Touch the
button repeatedly to select on or off for the touch beeps.
3. When error beeps is on, the Error beeps button indicates Error Beeps
on. When error beeps is off, it indicates Error beeps off. Touch the
button repeatedly to select on or off for the error beeps.
4. Touch the Display Units setting and select Meters or Feet.
5. Touch Exit to close the Display screen.
Touch Screen Calibration
If when touching a control, it does not respond, the touch screen display may
require calibration. For instructions on how to calibrate the touch screen
display, refer to "Calibrating the Touch Screen Display" on page 6-7.
User's Manual
TELEDYNE BENTHOS
P/N M-270-10, Rev. B
Advertisement
Table of Contents
