Table of Contents
Advertisement
B.PROTHERM 420 KBUH/420 KBRUH/620 KBUH/620 KBRUH
Cleaning and care
Warning!
Danger of scalding!
The unit lid does not close completely leak-tight, as otherwise a vacuum
would form during cooling, making it impossible to open the lid. As the lid
does not seal completely leak-tight, hot steam can exit the unit while keeping
the food hot, causing severe burns.
Open lid with great caution; wear protective gloves if necessary.
Change of location
The unit may be heavy when loaded. Lifting heavy loads can cause injuries.
This applies in particular for people who already have weakened musculo-
skeletal systems.
To minimize danger to your health, always lift the unit with a second person.
If possible, use suitable equipment to lift the unit.
Move the unit while upright, e.g. do not lay the unit on its side.
Hold unit door closed while changing its location.
Secure units stacked one on top of the other against tipping before changing
their location.
All possible measures must be taken to prevent risk to people or objects if a
mobile support such as a transport trolley is used to move a unit or two
stacked units. This includes the following:
Do not exceed the maximum load capacity of the support
Secure the unit(s) to the portable support so that they cannot tip over
Always move the unit(s) with two people
Only surfaces with an incline of less than 10° may be crossed
Secure the unit(s) from rolling away accidentally
The skids on the unit are worn down when it is moved directly on the floor.
To prevent the skids from wearing down, do not pull or push the unit directly
on the floor.
Under no circumstances push or pull crossways to the skids. Danger of tip-
ping.
The edges and corners of the synthetic body can be damaged by forceful im-
pacts. Water can seep into the unit walls in this case, especially when clean-
ing in a dishwasher.
Always handle the unit with care. Avoid impacts.
Hygiene
You must comply with the regulations in the 93/43/EEC hygiene directive and
national hygiene regulations.
Cleaning frequency
Clean the unit thoroughly after each use.
Cleaning methods
Use only approved cleaning methods.
Do not use pointed or sharp objects for cleaning.
Do not use a steam jet unit or high-pressure cleaner.
– 6 –
Advertisement
Table of Contents
