Loading The Unit - B.Pro B.PROTHERM 420 KBUH Translation Of The Original Operating Instructions


 Ensure that no objects which are sensitive to heat are located inside the
 Close the unit door.
 Connect the unit to the power supply.
B.PROTHERM 420 KBRUH/620 KBRUH
 Set the setpoint temperature if necessary.
 Preheat unit as long as desired.


Loading the unit








Hot convection heating!
The convection heating in the unit door becomes very hot during temperature
maintenance and can cause burns.
 When loading, avoid direct contact with the convection heating (inner
 If the unit is connected to the power supply, disconnect it.
 Open the unit door.
 Place the Gastronorm containers horizontally into the unit without jam-
 Lock unit door with locking lever.
 If necessary, reconnect the unit to the power supply after loading and
B.PROTHERM 420 KBUH/420 KBRUH/620 KBUH/620 KBRUH
Unit not loaded
unit.
 Section "Closing the unit door" on page 16.
 Section "Connecting unit" on page 10.
 Section "Setting the setpoint temperature" on page 14.
Always load the unit from bottom to top in order to keep the unit's centre
of gravity as low as possible.
B.PRO recommends loading with Gastronorm containers made of stain-
less steel (good heat conductivity compared to synthetic Gastronorm
containers).
Food may only be inserted into the unit if placed in covered Gastronorm
containers.
Always seal Gastronorm containers filled with liquid food with a sealing
lid.
Unit preheated if necessary (with small amount of food)
Food containers and food heated (containers not hotter than +100 °C)
Gastronorm containers in good condition (e.g. edge not deformed or
sharp)
Gastronorm containers covered (containers with liquid food provided with
sealing lids)
Warning!
side of unit door).
 Section "Opening a unit door" on page 15.
ming them.
 Section "Closing the unit door" on page 16.
continue heating.
– 17 –