Chapter 3 Basic Operation
3.2 Connect the Power Cord
Power connection, power cord WARNING and CAUTION are explained on pages ii to ⅷ at the
beginning of this instruction manual. Be sure to read the warnings and precautions before connect-
ing the power supply. The procedure for connecting the power supply is explained in ① and ②
below.
Connect the power cord
(1) Insert the connector of the accessory power cord into the AC LINE INPUT terminal for connecting the
power cord on the rear panel of the HC Unit. (See Figure 3.1)
(2) Connect the plug of the power cord to the power outlet. (See Figure 3.1)
In addition, connect to the power outlet to which the power cord of CS-8000 Series or Test Fixture is
connected and the power outlet as close as possible.
Power Cord
Power Plug
Power Outlet
3-2
AC LINE INPUT
Power Connector
Figure 3.1 Connection of Power Cord (CS-210)
HC UNIT CS-200 Series Instruction Manual
The Rear Panel of CS-210