The Rear Panel Of Hc Unit - Iwatsu CS-200 Series Instruction Manual

Chapter 2 Name and Functions

2.2 The Rear Panel of HC Unit

Figure 2.2 shows the rear panel of the CS-210 and explains the names and functions of each part.
① AC LINE INPUT
AC power input. Connect the included 3-prong power cord.
② Ground Terminal
The ground terminal for safety connected to the housing.
③ Fan Motor
The heat inside the instrument is exhausted by the fan motor.
④ CONTROL INTERFACE LED
You can confirm that it is blinking and communicating during the control operation from the CS-8000 Series.
⑤ CAL Connector
The BNC connector for inputting calibration voltage.
⑥ HC SENSE Connector
The amount of current output by this instrument is detected from this connector and the voltage is output to
the CS-8000 Series.
Connect to the CS-8000 Series with the optional HC standard cable set CS-022 interlock / sense cable.
⑦ CONTROL INTERFACE (IN) Connector
The connector for controlling each unit from the CS-8000 Series. It is used by connecting to the OUT side of
the CONTROL INTERFACE connector of the CS-8000 Series or the CONTROL INTERFACE connector of
other units.
When using multiple units, connect them with a daisy chain.
2-2
Figure 2.2 Rear panel view of HC Unit CS-210
HC UNIT CS-200 Series Instruction Manual