Table of Contents
Advertisement
Chapter 3
This chapter describes the precautions when installing the equipment in Section 3.1.
Section 3.2 describes the connection of the power cord and the connection with the CS-8000 Series
and Test Fixtures as preparations before measurement.
3.1 Install the Instrument
When using this Instrument, install it in a place and environmental conditions that meet the following
conditions.
☆ Flat and horizontal place
Install it in a stable place, keeping it horizontal on the left, right, front and rear. If you use it in an unstable place,
it may fall or fall, resulting in injury or malfunction.
☆ Well-ventilated place
This Instrument has a vent on the front and an exhaust on the rear. To prevent the temperature inside the
equipment from rising, leave sufficient space around it and do not block these vents and exhaust ports. Leave a
space of about 100 mm on the left, right, and rear of the Instrument.
☆ Stacking with optional items
This Instrument is used by connecting to a Test Fixture. Overlay the Test Fixture on top of the HC unit
However, when using the CS-8000 Series with the HC unit stacked, the angle adjustment stand on the front
side cannot be used upright. (The stand may be damaged)
☆ Performance ensured temperature, operation ensured temperature, humidity range
Performance ensured temperature range + 10 °C to + 35 °C (no condensation)
Ensured operation Temperature range, humidity range 0 ° C to + 40 °C, 5% to 80% RH, (30 °C, no
condensation)
Upper limit 55% RH (40 °C, no condensation)
CAUTION
!
If you move to an environment with different temperature and humidity, condensation may
occur due to sudden temperature changes.
If there is a change in the environment, wait for a while until the environment inside the
Instruments become accustomed to the surrounding environment.
Turn on the main power switch of the CS-8000 Series.
Basic Operation
HC UNIT CS-200 Series Instruction Manual
Chapter 3 Basic Operation
3-1
Advertisement
Table of Contents
