Lexmark MS531 User Manual page 69

Use printer menus
Menu item
Printer Emulations
PS Emulation
Off
On*
Printer Emulations
Enable Formsmerge
Off*
On
Printer Emulations
Enable Prescribe
Off*
On
Printer Emulations
Emulator Security
Page Timeout (60 minutes*)
Reset Emulator After Job (Off*)
Disable Printer Message Access (On*)
Print Configuration
Font Sharpening
0–150 (24*)
Print Configuration
Print Density
Disabled
1–5 (3*)
Device Operations
Quiet Mode
Off*
On
Device Operations
Safe Mode
Off*
On
Device Operations
Clear Custom Status
Device Operations
Clear all remotely‑installed messages
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Set the printer to recognize and use the PS data stream.
Activate Forms Merge to store the forms into the hard disk or
intelligent storage drive (ISD).
Note: A hard disk or an ISD must be installed.
Activate Prescribe.
Note: The Prescribe license must be installed.
Configure the security settings of the printer during emulation
mode.
Set a text point-size value below which the high‑frequency
screens are used when printing font data.
For example, if the value is 24, then all fonts sized 24 points or
less use the high‑frequency screens.
Adjust the toner density when printing documents.
Set the printer to operate in Quiet Mode.
Note: Enabling this setting slows down the overall
performance of the printer.
Set the printer to operate in a special mode, in which it attempts
to continue offering as much functionality as possible, despite
known issues.
For example, when set to On, and the duplex motor is
nonfunctional, the printer performs one‑sided printing of the
documents even if the job is two‑sided printing.
Erase user‑defined strings for the Default or Alternate custom
messages.
Erase messages that were remotely installed.
69