Tape Protect Menu; Time Code Menu - Panasonic AJ-D850 Operating Instructions Manual

USER menu
<TAPE PROTECT>
No.
400
401
402
403
The underline on the setting item denotes the initial setting.
<Note>
In order to protect the tape and VTR helical heads, it is recommended that the Still Timer be
set for automatic tape protection mode in 30 seconds or under.
<TIME CODE>
No.
500
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed Superimposed
No.
display display
STILL 0000
TIMER 0001
0002
0003
0004
0005
0006
0007
0008
SRC 0000
PROTECT 0001
DRUM 0000
STDBY 0001
STOP 0000
PROTECT 0001
Item Setting
Superimposed Superimposed
No.
display display
VITC 0000
POS-1 0001
0002
0003
0004
0005
0006
0007
0008
0009
0010
– 67 –
0.5s This selects the time to be taken until the unit goes into the
tape protection mode when it is left standing in the stop or
5s
search still (JOG/VAR/SHTL) mode. (Unit: s = second, min =
10s
minute)
20s
<Note>
30s
With the DV or DVCAM format, the maximum time which can
40s
be set is 10 s even when a setting above 10 s has been
50s
selected. The selection screen, however, will operate for up to
1min
2 minutes.
2min
STEP This selects the operation during the tape protection mode
when the unit is left standing in the still status during the
HALF
search mode (JOG/VAR/SHTL).
0: STEP FWD.
1: HALF LOADING.
<Note>
When STEP FWD is selected, the unit automatically goes into
the HALF LOADING mode when the total time for which the
unit is left standing in the still status reaches 30 minutes
(DVCPRO) or 1 minute (DV or DVCAM).
OFF
This selects the drum operation in the STANDBY OFF mode.
0: The drum stops rotating.
ON
1: The drum continues rotating.
STEP This selects the operation in the tape protection mode when
the unit has been left standing in the STOP mode.
HALF
0: STEP FWD
1: HALF LOADING
<Note>
When STEP FWD is selected, the unit is automatically
transferred to the HALF LOADING mode when the total time
during which it has been left standing in the STOP mode
reaches 30 minutes (or 1 minute with a DV/DVCAM tape).
10L This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-2 in 501 cannot be selected.)
11L
12L
13L
14L
15L
16L
17L
18L
19L
20L
Description
Description