Panasonic AJ-D850 Operating Instructions Manual page 92

Table of AUTO OFF Error messages
Counter display
REEL DIR UNMATCH
REEL TENSION ERROR
SERVO COMM ERROR
SERVO CONTROL
ERROR
SERVO ERROR
S-FF/REW TIMEOVER
S REEL ROTA TOO
FAST
S REEL TORQUE
ERROR
T REEL ROTA TOO
FAST
T REEL TORQUE
ERROR
UNLOAD ERROR
WINDUP ERROR
WINDUP REEL NOT
ROTA
Monitor display
If the reel motor at the take-up side is running in the
REEL DIR UNMATCH
reverse direction, the AUTO OFF lamp lights, and the
message display flashes.
If an abnormal tension at the supply side is detected
REEL TENSION ERROR
in the reel mode, the AUTO OFF lamp lights, and the
message display flashes.
When the servo microcomputer does not follow the
SERVO COMM ERROR
instructions of the system control microcomputer
even when 10 seconds have elapsed, the AUTO OFF
lamp lights, and the message display flashes.
When there is no response from the servo micro-
SERVO CONTROL
computer for 1 or more seconds, the AUTO OFF
ERR
lamp lights, and the message display flashes.
When only the servo microcomputer was reset in an
SERVO ERROR
instantaneous power failure, the AUTO OFF lamp
lights, and the message display flashes.
If the start/end processing operation is not completed,
S-FF/REW TIMEOVER
the AUTO OFF lamp lights, and the message display
flashes.
If the supply reel motor should rotate at an ab-
S REEL TOO FAST
normally fast rate, the AUTO OFF lamp lights, and
the message display flashes.
If an abnormal torque applied to the supply reel motor
S REEL TORQUE
is detected, the AUTO OFF lamp lights, and the
ERR
message display flashes.
If the take-up reel motor should rotate at an ab-
T REEL TOO FAST
normally fast rate, the AUTO OFF lamp lights, and
the message display flashes.
If an abnormal torque applied to the take-up reel
T REEL TORQUE
motor is detected, the AUTO OFF lamp lights, and
ERR
the message display flashes.
If the tape has not been wound up during unloading,
UNLOAD ERROR
the AUTO OFF lamp lights, and the message display
flashes.
If the tape was not wound up at less than the
WINDUP ERROR
standard speed (1 ) when the total tape amount was
not detected or if abnormal tape slack or tension was
detected at speeds above 1
amount was detected, the AUTO OFF lamp lights,
and the message display flashes.
If, after the cassette has been inserted, the tape take-
W-UP REEL NOT ROTA
up reel has not wound up the tape at the standard
speed (1 ) or faster while the total tape amount is not
detected and while the tape is traveling in the forward
or reverse direction, the AUTO OFF lamp lights, and
the message display flashes.
Description
– 92 –
VTR operation
(Restart condition)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
(POWER OFF® ON)
STOP
after the total tape (POWER OFF® ON)
STOP
(POWER OFF® ON)