Panasonic AJ-D850 Operating Instructions Manual page 60

Setup menus
USER menu
<OPERATION>
No.
108
112
113
The underline on the setting item denotes the initial setting.
Memory stop function
z When the FF button is pressed, the VTR performs the regular fast forward operation since the zero point is not located in the
direction of operation.
x When the REW button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the
preroll operation, and it automatically stops when it reaches the position where the counter reads "0."
c When the REW button is pressed, the VTR performs the regular rewinding operation since the zero point is not located in the
direction of operation.
v When the FF button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the preroll
operation, and it automatically stops when it reaches the position where the counter reads "0."
(continued)
Item Setting
Superimposed Superimposed
No.
display display
FORMAT 0000 DVCPRO
SEL 0001
0002 DVCAM
AUTO REW 0000
0001
MEMORY 0000
STOP 0001
FWD direction
3 REW button
4 FF button
– 60 –
These settings are for selecting the format when an L cassette
or S cassette is used.
DV
0: L cassette DVCPRO mode
S cassette DV mode
1: L cassette/S cassette
2: L cassette/S cassette
<Notes>
Bear in mind that, in addition to problems with playback, the
trouble described below may occur when a tape which does
not match the selected format is inserted.
1. If a DV or DVCAM tape is inserted when the DVCPRO
mode setting has been selected, the recording operation
will be conducted but no guarantee is given for the resulting
performance, etc. Conversely, recording is not possible if a
DVCPRO cassette tape is inserted when the DV or
DVCAM mode setting has been selected.
2. The REMAIN display fails to appear properly.
3. The slow-down position near the tape start or end is not
located accurately.
4. When a tape which does not match the selected format is
inserted, no guarantee is given for the resulting perform-
ance, etc.
OFF This selects whether to rewind the tape automatically to the
tape start when the tape end is detected.
ON
0: The tape stops at the tape end.
1: The tape is rewound to the tape start.
OFF This selects whether the VTR is to stop automatically when
the counter value reaches "0" during a fast forwarding or
ON
rewinding operation in the CTL mode.
0: The VTR does not stop.
1: The VTR stops automatically.
<Notes>
1. The stop mode concerned is either the stop or the still-
picture (SHTL STILL) mode depending on the setup menu
No. 313 (AFTER CUE-UP) setting.
2. When both the AUTO REW function and MEMORY function
have been selected at the same time, the AUTO REW
function takes precedence.
The MEMORY STOP function does not work if it is
activated within a range of 0 2 frames.
Zero
point
1 FF button
2 REW button
Description
DV mode
DVCAM mode