Panasonic AJ-D850 Operating Instructions Manual page 68

Setup menus
USER menu
<TIME CODE>
No.
501
502
503
504
505
506
507
508
509
The underline on the setting item denotes the initial setting.
(continued)
Item Setting
Superimposed Superimposed
No.
display display
VITC 0000
POS-2 0001
0002
0003
0004
0005
0006
0007
0008
0009
0010
VITC 0000
BLANK 0001
TCG 0000
REGEN 0001
0002
REGEN 0000
MODE 0001
0002
0003
EXT TC 0000
SEL 0001
BINARY 0000
GP 0001
0002
0003
0004
0005
0006
0007
PHASE 0000
CORR 0001
TCG CF 0000
FLAG 0001
DF MODE 0000
0001
– 68 –
10L This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-1 in 500 cannot be selected.)
11L
12L
13L
14L
15L
16L
17L
18L
19L
20L
BLANK
This selects whether to output the VITC data to the positions
THRU
selected by VITC POS-1 in 500 and VITC POS-2 in 501.
0: Data is not output.
1: Data is output.
TC&UB
This selects the signal to be regenerated when the time code
TC generator (TCG) in the REGEN mode.
0: Both the time code and user bit are regenerated.
UB
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
AS&IN
This selects whether the time code is to be regenerated during
ASSEM
automatic editing using the unit's control panel.
0: Time code is regenerated with assemble or insert editing.
INSRT
1: Time code is regenerated with assemble editing.
SW
2: Time code is regenerated with insert editing.
3: Setting complies with REGEN/PRESET switch setting.
LTC
This selects the time code to be used when an external time
code is to be used.
VITC
0: The LTC of the TIME CODE IN connector is used.
1: The video signal VITC is used.
000 This sets the usage status of the user bit of the time code
generated by the TCG.
001
0: NOT SPECIFIED (character set not specified)
010
1: ISO CHARACTER (8 bits character set based on ISO646,
011
ISO2022)
100
2: UNASSIGNED 1 (undefined)
101
3: UNASSIGNED 2 (undefined)
110
4: UNASSIGNED 3 (undefined)
111
5: PAGE/LINE
6: UNASSIGNED 4 (undefined)
7: UNASSIGNED 5 (undefined)
OFF
This selects whether to control the phase correction of the
LTC generated by the TCG.
ON
0: Phase correction control is not performed.
1: Phase correction control is performed.
OFF This selects whether the CF flag of the TCG is to ON.
0: CF flag is OFF.
ON
1: CF flag is ON.
DF
This selects the DF/NDF mode for CTL and TCG.
0: Drop frame mode.
NDF
1: Non-drop frame mode.
No. 509 is valid when the CONTROL is LOCAL or LOCAL
ENA of item 004 to "ENA".
Description