Panasonic AJ-D850 Operating Instructions Manual page 70

Setup menus
USER menu
<VIDEO>
No.
600
601
602
603
604
605
606
608
610
611
613
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed Superimposed
No.
display display
P /P 0000
B R
IN LV 0001
INT BB 0000
SIG 0001
INPUT C 0000
KILL 0001
OUT 0000
VSYNC 0001
V-MUTE 0000 N-MUTE
SEL 0001 LOW RF
CC (F1) 0000
BLANK 0001
CC (F2) 0000
BLANK 0001
FREEZE 0000
SEL 0001
OUT C 0000
KILL 0001
EDH 0000
0001
VIN SETUP 0000
0001
– 70 –
M II This selects the component input signal level.
0: M II level.
B-CAM
1: ß cam level.
OFF
This selects whether to generate the internal black burst
BB signal.
0: Signal is not generated.
1: Signal is generated.
B/W This selects color killer processing for the video input signals.
0: The signals are forcibly processed as B/W signals.
AUTO
1: The signals are automatically processed.
N-VF
This selects whether to float the vertical sync position of the
video output in order to align the video output phase with
VF
the input in the EE/record/edit modes.
0: Signals are not floated.
1: Signals are floated.
This selects whether the video output signals are to be muted
when the blank portion of the tape is detected during play-
back.
0: No muting. (Freeze)
1: Muting. (Set to gray.)
BLANK This selects ON or OFF for the closed capture signal in the
first field.
THRU
0: Forced blanking performed.
1: Blanking not performed.
BLANK This selects ON or OFF for the closed capture signal in the
second field.
THRU
0: Forced blanking performed.
1: Blanking not performed.
FIELD This selects the freeze mode for still pictures.
0: Field freeze.
FRAME
1: Frame freeze.
<Note>
When frame freeze has been selected, the frame slow status
is established with the slow setting.
B/W This selects chroma color killer processing for the video output
signals.
COLOR
0: The signals are forcibly processed as B/W signals.
1: The signals are automatically processed.
OFF This selects whether to superimpose EDH onto the serial
output signals.
ON
0: EDH is not superimposed.
1: EDH is superimposed.
<Note>
This item is valid when the optional serial interface board has
been installed.
THRU This selects whether the composite signal is to be recorded
with setup or without setup.
CUT
0: When recording signals with no setup.
1: When recording signals with 7.5% setup.
<Note>
When recording composite signals, be sure to double-check
whether the signals are to be recorded with or without setup.
Description