Omron NX Series Hardware User Manual page 61

Configuration software
CX-Protocol
CX-Designer
*1. If the NJ/NX-series Controller is a target device, you may also use Sysmac Studio version 1.10 or higher. Use the Network
Configurator if a CS/CJ-series PLC operates as the originator device.
NX-series NX502 CPU Unit Hardware User's Manual (W629)
The CX-Protocol is used for protocol macros with the CJ-series Serial Communications
Units.
The CX-Designer is used to create screens for NS-series PTs.
1 Introduction to NX-series Controllers
Application
1
1-9