Omron NX Series Hardware User Manual page 146

5 Installation and Wiring
Use one screw for each three holes.
• Using an NS 35/7,5 PERF or NS 35/15 PERF DIN Track
Use one M6 screw for each four holes in the DIN Track. There must be a screw for each inter-
val of 100 mm or less. The screw tightening torque is 5.2 N·m.
Use one screw for each four holes.
2
Make sure that the DIN Track mounting hook on the CPU Unit is in the unlock position.
DIN Track Mounting Hooks
in Locked Position
If the DIN Track mounting hooks are pulled up, they are in the unlocked position.
If the DIN Track mounting hooks are pressed down, they are in the locked position.
Use a flat-blade screwdriver to pull up the DIN Track mounting hook on the Unit to release the
locked position.
3
Press the CPU Unit straight against the DIN Track.
5-16
DIN Track
DIN Track
DIN Track mounting hooks
4.5 mm
POWER
PORT2 PORT2
DIN Track Mounting Hooks
in Unlocked Position
NX-series NX502 CPU Unit Hardware User's Manual (W629)
6.9 mm
POWER