Omron NX Series Hardware User Manual page 60

1 Introduction to NX-series Controllers
Information Level
EtherNet/IP
Built-in EtherNet/IP ports
NJ-series
CPU Unit
CompoNet Master Unit
DeviceNet Unit
Field Level
CompoNet
MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
OUT OUT
CRT1-OD16 CRT1-OD16
REMOTE TERMINAL REMOTE TERMINAL
CompoNet slaves
DeviceNet slaves
Refer to the NJ/NX-series CPU Unit Software User's Manual (Cat. No. W501) for details on the net-
work configuration.
Support Software
You can use the following Support Software to set up, monitor, and debug an NX-series Controller.
• Sysmac Studio
The Sysmac Studio is the main Support Software that you use for an NX-series Controller. On it,
you can set up the Controller configurations, parameters, and programs, and you can debug and
simulate operation.
• Other Support Software
The following Support Software is also included in the Sysmac Studio Software Package Standard
Edition.
Configuration software
Sysmac Studio
Network Configurator
CX-Integrator
1-8
FA Communica- Sysmac
tions Software
Studio
NX-series
NX502
CPU Unit
Built-in
EtherNet/IP port 1
Built-in EtherNet/IP
port 2
Built-in EtherCAT
port
Serial Communica-
tions Unit
RS-232C,
RS-422A/485
Serial communications devices
MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
OUT
CRT1-OD16
REMOTE TERMINAL
General-purpose components or OMRON components
DeviceNet
The Sysmac Studio is used for sequence control, motion control, and all other operations
except those described below.
The Network Configurator is used for tag data links on EtherNet/IP ports.
The CX-Integrator is used for remote I/O communications with a CJ-series DeviceNet Unit
or CJ-series CompoNet Master Unit.
FA Wireless
LAN Unit
Programmable
POWER
Terminal
PORT2
NX-series Communications
Interface Unit
Serial communications devices
General-purpose components or OMRON components
EtherCAT
General-purpose
slaves
EtherCAT
Servo Drives
Slave Terminal
EtherNet/IP
RFID system
Application
NX-series NX502 CPU Unit Hardware User's Manual (W629)
NJ/NX-series
CPU Unit
Vision
Systems
Robots
*1