Omron NX Series Hardware User Manual page 219

POWER............................................................................. 3-7
Power OFF Operation....................................................... 5-3
power supply-related Unit..................................................4-4
Power Supply-related Unit...............................................3-15
preventing incorrect attachment of terminal blocks......... 5-52
Protective device............................................................. 4-25
R
Recommended Power Supplies............................. 4-22, 4-24
Recommended screwdriver ............................................5-45
removing a terminal block................................................5-51
replacement battery...........................................................7-6
Required Power Supply Capacity of the I/O Power Supply....
..................................................................................... 4-24
Required Power Supply Capacity of the Unit Power Supply..
..................................................................................... 4-22
restricted region.........................................................21, 5-15
Restrictions on Inrush Current.........................................4-20
RUN...................................................................................3-7
S
Safe Mode......................................................................... 3-6
SD BUSY...........................................................................3-8
SD Memory Card.............................................. 2-5, 2-6, 5-24
SD Memory Card connector.............................................. 3-4
SD Memory Card cover..................................................... 3-5
SD Memory Card power supply switch..............................3-4
SD PWR............................................................................ 3-7
Securing Wires................................................................ 5-47
Selecting Protective Device.............................................4-25
slider ................................................................................. 3-4
solid wires........................................................................5-45
special marker printer...................................................... 5-18
Star earthing...........................................................5-64, 5-65
Startup............................................................................... 3-7
supply from external source............................................ 4-14
supply from the NX bus................................................... 4-14
Support Software........................................................1-6, 1-8
Sysmac Studio.................................................................3-18
T
The voltage drop in the I/O power supply...............4-15, 4-18
twisted wires.................................................................... 5-45
U
Unit hookup guides............................................................3-4
Unit power supply............................................................ 4-22
Unit Version..................................................................... 3-13
W
Wiring Ducts.................................................................... 5-10
Wiring the Unit Power Supply..........................................5-36
X
NX-series NX502 CPU Unit Hardware User's Manual (W629)
X Bus connector................................................................ 3-5
X Bus Unit................................................................ 2-6, 3-17
X Bus Unit configuration.............................................2-2, 2-5
Index
I
I-3