Omron NX Series Hardware User Manual page 173

Terminal types
All terminals except
ground terminals
Ground terminals
All terminals except
ground terminals
*1. This represents a typical model. Actually, colored codes and other information is added.
*2.
Although wires exceeding 2.0 mm
clamping terminal block.
When you use any ferrules other than those in the above table, crimp them to the twisted wires so
that the following processed dimensions are achieved.
1.6 mm max.
(Terminals other than ground terminals)
2.0 mm max.
(Ground terminals)
l Using Twisted or Solid Wires
If you use twisted wires or solid wires, use the following table to determine the correct wire specifi-
cations.
NX-series NX502 CPU Unit Hardware User's Manual (W629)
Applica-
Ferrule
Manufac-
*1
turer
model
Phoenix AI0,34-8 0.34 (#22)
Contact
AI0,5-8 0.5 (#20)
AI0,5-10
AI0,75-8 0.75 (#18)
AI0,75-10
AI1,0-8 1.0 (#18)
AI1,0-10
AI1,5-8 1.5 (#16)
AI1,5-10
AI2,5-10
2.0
Weidmul- H0.14/12 0.14 (#26)
ler
H0.25/12 0.25 (#24)
H0.34/12 0.34 (#22)
H0.5/14 0.5 (#20)
H0.5/16
H0.75/14 0.75 (#18)
H0.75/16
H1.0/14 1.0 (#18)
H1.0/16
H1.5/14 1.5 (#16)
H1.5/16
2
are available for AWG14, they cannot be used for the screwless
8 to 10 mm
5 Installation and Wiring
ble wire
Crimping tool
2
(mm
(AWG))
Phoenix Contact (Applicable wire size given
in parentheses)
CRIMPFOX 6 (0.25 to 6 mm
10)
*2
Weidmuller (Applicable wire size given in
parentheses)
PZ6 Roto (0.14 to 6 mm
2.4 mm max.
(Terminals other than ground terminals)
2.7 mm max.
(Ground terminals)
2
, AWG24 to
2
, AWG26 to 10)
5
5-43