Table of Contents
Advertisement
V.
Side A/V Input Board Removal
Although the side input board can be removed from the back, it is not possible to re-
insert it that way without damage.
T
o properly access the side input board, remove the front light gray (silver) panel that
holds the power-on pushbuttons.
Procedure:
1. Remove the screw at the light gray panel
2. Lift its tab to clear the boss underneath
3. Slide the panel off to the right, exposing the side board underneath.
4. Remove the two screws that hold the input board in place
5. Slide the input board out from the front hole.
Refer to figure 49.
Lift tab after
removing screw
Figure 49 - Front control panel
Light gray panel
52
Advertisement
Table of Contents
