Leveling Components; Lid; Consumables And Spare Parts; Hematek Stain Pak - Modified Wright's Stain - Siemens Hematek 3000 System Instruction Manual

4 Description
4.1.4

Leveling components

Circular bubble level
Leveling feet
4
4.1.5

Lid

4.2

Consumables and spare parts

4.2.1

Hematek Stain Pak - Modified Wright's Stain

4 12
The circular bubble level is located on top of the system, at the right side
next to the stain pump assembly. The circular bubble level is a water bubble
gauge with an inscribed circle that can be observed through the lid. It is
used to ensure the slide stainer is in a level position.
The two feet under the front corners of the system act as levelers and can
be adjusted to raise or lower the slide stainer to a level position. Observe
the circular bubble level to verify that the leveling feet have been properly
adjusted and the system is level.
The third foot at the rear is fixed.
The lid covers the rear part of the slide stainer including the Hematek Stain
Pak.
This section lists the consumables and spare parts for the slide stainer. For
more details, for example, order numbers, refer to the current Siemens
product catalog or contact the Siemens service.
Instructions for using the consumables are given in the respective
procedures in this manual.
A Hematek Stain Pak - Modified Wright's Stain is displayed in Figure 4-13.
Figure 4-13 Hematek Stain Pak - Modified Wright's Stain
®
Hematek 3000 System – Instruction Manual – Version 1.3