8 Troubleshooting
8.2
Leveling the system
8
8
4
To level the system, proceed as follows:
1. Place the system on a firm, level work surface.
2. Raise the lid, see Figure 8-1.
3
1 Lid
2 Circular bubble level
3 Leveling feet
system
Figure 8-1 Leveling the
3. Turn the two leveling feet located under the front corners of the system
to raise or lower the system to a level position.
4. At the right side of the system, observe the circular bubble level to check
when the leveling feet have been properly adjusted and the system is
level.
5. Repeat step 3 and step 4 until the bubble in the circular bubble level is
centered within the inscribed circle.
®
Hematek
3000 System – Instruction Manual – Version 1.3
1
2
3