Advertisement
Advertisement
Related Manuals for Siemens Healthineers UniPOC RAPIDPoint 500
Summary of Contents for Siemens Healthineers UniPOC RAPIDPoint 500
- Page 1 Configuration Guide RAPIDPoint 500 RAPIDPoint 500e from software version 1.6...
- Page 2 All other trademarks are the property of their respective owners. The information in this manual was correct at the time of printing. However, Siemens Healthcare Diagnostics continues to improve products and reserves the right to change specifications, equipment, and maintenance procedures at any time without notice.
-
Page 3: Table Of Contents
RAPIDPoint 500/RAPIDPoint 500e Configuration Guide Table of Contents Introduction ............................4 Intended Use ............................4 Instrument Configuration Pages ......................4 Configuration Screens ........................... 5 Download Options ......................... 6 Instrument Settings ........................7 Support ..............................8 RAPIDPoint 500/RAPIDPoint 500e Configuration Guide 11555620, Rev. -
Page 4: Introduction
RAPIDPoint 500/RAPIDPoint 500e Configuration Guide 1 Introduction This manual describes the use of the UniPOC ™ Point of Care Data Management System software to ® ® configure the RAPIDPoint 500 and RAPIDPoint 500e device. Please read this configuration guide for step-by-step instructions and illustrations on how to configure the devices prior to placing them in service. -
Page 5: Configuration Screens
RAPIDPoint 500e configuration data for a specific location. These devices can be configured for the entire Organization or for an individual Facility, Department or Location. Note: Siemens recommends entering configuration data at the Facility level when possible. Department level settings should then be used to vary the instrument configurations only as needed. The Organization level settings then remain available for reference as default values. -
Page 6: Download Options
RAPIDPoint 500/RAPIDPoint 500e Configuration Guide the Tree. Breaking the Parent-Child relationship is necessary to enable configuration settings different from the global Organization or Facility. Refer to the UniPOC User’s Manual for more information about the Location Tree Parent- Child Relationship. •... -
Page 7: Instrument Settings
RAPIDPoint 500/RAPIDPoint 500e Configuration Guide 4.2 Instrument Settings Each operator is assigned to a home Location within a Facility. Each Facility in the organization maintains a separate operator list. Instrument settings saved at the Facility level affect the Department and Location levels as well. -
Page 8: Support
RAPIDPoint 500/RAPIDPoint 500e Configuration Guide 5 Support Contacting Siemens Support Siemens is committed to helping you resolve any problems with the UniPOC™ Point of Care Data Management System. For assistance, contact POC Informatics Customer Service: https://www.siemens-healthineers.com/point-of-care-testing/featured-topics-in-poct/informatics-featured- topics/poc-informatics-customer-service-contacts UniPOC_ConfigurationGuide_RP500_EN.docx Template Used: 99e_UniPOC_ConfigurationGuide.dotx RAPIDPoint 500/RAPIDPoint 500e Configuration Guide 11555620, Rev.