Table of Contents
Advertisement
Cleaning and care
Although this appliance
automatically defrosts, a layer of frost
may occur on the freezer
compartment's interior walls if the
freezer door is opened frequently or
kept open too long. If the frost is too
thick, choose a time when the freezer
is nearly empty and proceed as
follows:
1. Remove existing food and
accessories baskets, unplug the
appliance from the mains power
and leave the doors open.
Ventilate theroom thoroughly to
accelerate theprocess.
2. When defrosting is completed,
clean your freezer as described
above.
Warning
Do not use sharp objects to
remove frost from the freezer
compartment
Only after the interior is
completely dry should the
appliance be switched back on
and plugged back into the main
socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution
Only after the door seals are
completely dry should the
appliance be powered on.
Warning
The LED light must be replaced by
a competent person. If the LED
light is damaged, follow the steps
below：
1. Unplug your appliance.
2. Remove the light cover by
lifting up and pulling out.
3. Hold the LED light with one
hand and pull it while pressing
the connector latch with the
other hand.
4. Replace the LED light and snap
it correctly in place and replace
the light cover
31
Advertisement
Table of Contents
