Table of Contents
Advertisement
Installing your new appliance
Door Removal
In case your home access door is too
narrow for the refrigerator to pass
through, remove the refrigerator
doors and drawers. If you do not
need to remove the appliance doors,
proceed to Installing Water Lines' on
page 12.
If you need to remove the doors,
continue below.
Tools you will need(Not provided)：
Allen Wrench (5/32",4mm)
Philips Screwdriver
1. With the door closed, remove the 3
screws holding the top cover with
Philips (+) screwdriver, and then
remove the top cover with the entire
harness attached.
Wrench (5/16",8mm)
Top cover
2. Separate the two connectors on
the left side door. To remove the wire
connector, press the top of the
connector and separate it from the
other one. To remove the water
coupler from the hinge, twist and pull
the clips from the coupler. Remove
the water line while pressing the
movable part of the water line
coupler.
Connector
Water line
3. Remove the screws fixed on the
hinges with a wrench ( 5/16",8mm)
and 1 ground screw attached to the
hinge with Philips (+) screwdriver.
Remove the upper left and right door
hinges .
Screws
Ground
screw
Upper
door hinge
Movable
part
Clip
09
Advertisement
Table of Contents
