Place The Camera Upside-Down By Fixing On The Bracket; Place The Camera Upside-Down On A Desktop Without Fixing - Panasonic WV-NS202A Installation Manual

Place the camera upside-down by fixing on the bracket

When using the camera upside-down, fix the camera using the provided camera mount bracket to prevent a fall.
Install the camera by following step 1 and steps 3 – 8 of the "Wire through a hole in the ceiling" section ( pages 14 -
16).
When using the camera upside-down, select "ON (desktop)" for "Upside-down" on the [Camera] tab of the setup
menu. ( Network operating instructions (PDF)).

Place the camera upside-down on a desktop without fixing

Place the camera on a level place not subject to vibrations. Ensure that the camera does not fall.
When using the camera upside-down, select "ON (desktop)" for "Upside-down" on the [Camera] tab of the setup
menu. ( Network operating instructions (PDF)).
18
Important:
Prepare four fixing screws (M4 or M6) to be used to
mount the provided mount bracket according to
the material of the place where the camera mount
bracket is to be installed.
When connecting to a DC 12 V power supply, pass the
power cord from a DC 12 V power supply through the
cable guides after inserting the DC 12 V power cord
plug into the DC 12 V power terminals.
Refer to page 16 for how to connect to a DC 12 V
power supply.
Power cable
Cable guide