Rear View - Panasonic WV-NS202A Installation Manual

Rear view

Link LED
Network connector
DC 12 V power terminals
Power LED
• About the [INITIAL SET] button
Turn on the power of the camera while holding down this button, and wait for around 5 seconds without releasing
this button. Wait another 1 minute after releasing the button. The camera will restart and the settings including the
network settings will be initialized.
The settings including the network settings will be initialized. Note that the preset position settings will not be ini-
tialized.
12
[INITIAL SET] button
Cable guide
Access LED
10BASE-T/
100BASE-TX
ACT INITIAL POWER 4 3 2 1
LINK
SET
MIC IN
12V IN
EXT I/O
Screw hole for a tripod (1/4-20UNC)
Important:
Audio output connector
Monitor out connector
AUDIO OUT MONITOR OUT
Safety wire holder
Microphone in connector
External I/O terminals
Use this hole only when the camera is to be
installed on desktop using a tripod.
Do not use this hole to mount on the ceiling since
the fall prevention measure is unavailable.