Camera Mount Bracket (W/Safety Wire) - Panasonic WV-SC385 Installation Manual

Wire through a hole in the ceiling
Step 1
Fix the camera mount bracket (accessory) with four
optional fixing screws (M4 or M6, option).
There should be no obstacles such as wall in a range of
100 mm {3-15/16"} away from the center point of the
camera mount bracket.
Shooting direction (FRONT)
Step 2
Make a hole in the ceiling to pass the cables through.
Make a hole 25 mm {31/32"} in diameter. The center point
of the hole should be located approx. 75 mm {2-15/16"}
away from the center point of the camera mount bracket.
Wiring hole
(ø25 mm {31/32"})
16
83.5 {3-9/32"}
110 {4-5/16"}
100 mm {3-15/16"} or more away
from obstacles such as wall
Step 3
Insert the SDHC/SD memory card into the SDHC/SD
memory card slot. Refer to page 24 for how to insert the
SDHC/SD memory card.
Step 4
Attach the safety wire fixed with the camera mount
bracket (accessory) to the camera.
After attaching the safety wire to the camera, confirm that
the ring part at the end of the safety wire is securely
hooked on the safety wire holder.
Screw
(M4)
Screw
(M6)
Step 5
Connect cables to the External I/O terminals, microphone/
line input connector, audio output connector and the
monitor out connector for adjustment. When connecting
these cables, hold the base part of the camera.
Microphone/line
input connector
External I/O terminals
10BASE-T/
100BASE-TX
LINK
Base
part
• External I/O terminals
Connect external devices.
When connecting an external device, remove 9 mm -
10 mm {11/32" - 13/32"} of the outer jacket of the cable
and twist the cable core to prevent the short circuit first.
Safety wire holder
Audio output connector
POWER
ACT INITIAL EXT I/O
AUDIO OUT
MIC/LINE IN MONITOR OUT
SET
12V IN
4 3 2 1
Safety wire
Monitor out
connector for
adjustment