Ftp Client Setup - Panasonic WV-NP472 Operating Instructions Manual

3. E-Mail Notice Setup
• Select ON or OFF for E-mail Notice.
ON: Sends an e-mail when an alarm operates.
OFF: Does not send.
• Enter the e-mail server address.
A hostname.domainname can be entered
when using the DNS function.
• Enter the sender name. The default setting is
NW_camera.
• Select ON or OFF for Attach Image.
ON: Attaches the image data to an e-mail.
OFF: Does not attach.
• Click the SET & REBOOT button.
• Enter a maximum of 4 destination addresses,
and click the SET button.
• Click the DEL (delete) button after selecting an
unwanted destination to cancel it.
4. Recording Setup
The image fields are stored before and after the
alarm input in the memories of the camera.
• Set the image frame numbers for the pre
recording (0 – 20) and post recording (1 – 20).
• Set the recording rate (fps: frame per second).
Rates for Before: 1/10, 1/5, 1/3, 1/2, 1, 2, 3.3, 5
Rates for After: 1/10, 1/5, 1/3, 1/2, 1, 2, 3.3, 5,
10
• Click the SET&REBOOT button.
5. Panasonic Protocol Setup
• Select ON or OFF.
ON: Sends alarm notice mails to the cus-
tomized destinations.
OFF: Does not send.
• Enter the destination port.
exclusively assigned to this function, and
any other usage is not allowed.
• Enter the retry times from 1 to 25.
• Click the SET button.
• Enter a maximum of 8 destination IP address-
es, and click the SET button.
• Click the DEL (delete) button after selecting an
unwanted destination to cancel it.
6. External Terminal Output Setup
The alarm output is supplied from the terminal on
the rear of the camera.
• Select a signal type that the connected device
accepts.
Pulse: Holds active status during the specified
time width.
Latch: Holds active status until it is reset man-
ually.
• Enter pulse width (n x 100 milli-seconds) if you
selected Pulse. A number from 1 to 100 is
allowed.
• Click the SET&REBOOT button.
7. Alarm Reset
• Click the ALARM RESET button to cancel the
activated alarm.
The port number is
-33-

FTP Client Setup

Image files can be transferred to the FTP server within
the scheduled time zone.
1. Open the FTP Client Setup window.
2. Common Setup
• Enter the FTP server address.
A hostname.domainname can be entered
when using the DNS function.
• Enter the user name with a maximum of 16
characters.
• Enter the password with a maximum of 16
characters.
• Select a transmission mode from Sequential or
Passive. Passive is recommended when
Sequential does not perform properly.
• Complete the schedule 1 and 2, by specifying
the transmission time zone and the day of a
week.
3. None Alarm (FTP) Image Transmission Setup
• Select ON or OFF to transmit ordinary image
files except during an alarm event.
ON: Transmits files when a scheduled time
comes.
OFF: Does not transmit, and no schedule is
applied.
• Enter a receiver directory.