Installations; Mounting And Adjusting The Lens - Panasonic WV-NP472 Operating Instructions Manual

INSTALLATIONS

Mounting and Adjusting the Lens

Replacement of Auto Iris Lens Connector
If necessary, replace the existing lens connector with
the type YFE419J100 supplied.
1. Cut the existing lens connector from the iris control
cable at its end.
2. Process the cable end as shown in the figure.
3. Solder each wire to the pin.
Pin #1: Red/Power
Pin #2: Not used
Pin #3: White/Video
Pin #4: Black/GND, Shield
Pin 3
Pin 1
4. Attach the cover to the connector.
Cover
8 mm (5/8")
2 mm (1/16")
Rib
Pin 4
Pin 2
Lens
Mounting the Lens
Notes:
• Using the lens having improper protrusion will
damage the camera. The protrusion of the lens into
the camera body should be within the length indi-
cated in the figure.
C-mount:
CS-mount: Less than 8 mm (5/16")
• Secure both the lens and camera with the support-
er (not supplied) if a lens heavier than 450 g
(0.99 lbs) is mounted.
1. Attach the supplied C-mount adapter when using a
C-mount lens.
The camera at the factory shipment can accept
only a CS-mount lens.
2. Jump to step 3 if the lens has focus adjusting
mechanism. Loosen the flange-back screw, and
rotate the adjusting ring down until it stops on the
side of the camera.
W V
- N P 4
7 2
Flange-back
Adjusting Ring & Screw
3. Mount the lens.
4. Connect the lens cable to the auto iris connector
on the side of the camera.
N P 4
7 2
-8-
Less than 13 mm (1/2")
Lens Mount
C-mount Adapter