Network Setup Of The Camera - Panasonic WV-NP472 Operating Instructions Manual

6. Click "Internet Protocol (TCP/IP)", and then click
the [Properties] button.
7. Click the "Use the following IP address" radio but-
ton and enter the IP address and the subnet mask
as follows.
IP address
Subnet mask
8. Click the [OK] button, and the window dialog box
closes.
: 192.168.0.9
: 255.255.255.0

Network Setup of the Camera

On completion of the network setup of the PC, begin
the network setup of the camera. If multiple cameras
are connected, it is required to set up each camera
individually. The following information is necessary for
the network setup of the camera. If you do not have the
following information, refer to your network administrator
or your Internet service provider.
• IP address
• Subnet mask
• Default gateway (when using a gateway server or a
router)
• Port number
• DNS server address 1 and/or 2 (when using DNS)
1. Start up Internet Explorer on your PC.
2. Enter "192.168.0.10" (the default IP address of the
camera) in the address bar. The main page of the
camera appears.
-25-