Panasonic WV-NP472 Operating Instructions Manual page 27

Connection type 2
Connection type 3
IP address
Subnet mask
Default gateway
Network speed
HTTP port
Host name
DNS
Primary server
Secondary server
DHCP
IP address
Subnet mask
Default gateway
Network speed
HTTP port
Host name
DNS
Primary server
Set the IP address designated by your network administrator.
However, the setting is not required if DHCP is used in an
intranet.
Set the subnet mask designated by your network administra-
tor.
However, the setting is not required if DHCP is used in an
intranet.
Set the IP address of the default gateway designated by your
network administrator.
However, the setting is not required if DHCP is used in an
intranet.
Set the network speed.
Use the default setting "auto" for the network speed.
Selectable parameters: auto (default setting), 100 Mbps (full
duplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10
Mbps (half duplex)
Use the default setting "80" for the HTTP port.
Refer to your network administrator and set the designated
host name if required.
Set to ON when using the DNS server.
No setting required
Set the IP address of DNS when using the DNS server.
Refer to your Internet service provider for the IP address of
DNS. Primary and secondary IP addresses can be set for the
DNS.
Set to ON if the intranet uses DHCP.
Set the IP address designated by your Internet service
provider.
However, the setting is not required if your Internet service
provider uses a DHCP server (the DHCP server assigns an
IP address to the camera automatically).
Set the subnet mask designated by your Internet service
provider.
However, the setting is not required if your Internet service
provider uses a DHCP server (the DHCP server assigns an
IP address to the camera automatically).
Set the default gateway designated by your Internet service
provider.
Set the network speed.
Use the default setting "auto" for the network speed.
Selectable parameters: auto (default setting), 100 Mbps (full
duplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10
Mbps (half duplex)
Use the default setting "80" for the HTTP port.
Refer to your Internet service provider and set the designated
host name if required.
Set to ON when using the DNS server.
No setting required
-27-