Panasonic WV-CL920A Operating Instructions Manual page 40

5. Move the cursor to LEVEL and select the illumi-
nance level using L or M.
LOW: Color picture switches to black-and-white at
approx.1 lx with F1.4 lens.
HIGH: Color picture switches to black-and-white at
approx.5 lx with F1.4 lens.
The factory default setting is HIGH.
6. Move the cursor to DURATION TIME to set the
switching time using L or M.
The following switching times are available:
10s--30s--60s--300s
(S)
10-7. BURST (BW)
1. Move the cursor to the BURST (BW) parameter.
2. Select ON or OFF using L or M.
Default: ON
ON: The burst signal is supplied along with the
black and white composite video signal.
OFF: The burst signal is not output.
Note: Select the appropriate mode for the con-
nected recording device and monitor TV
when setting BW (10-6) and burst signal
(10-7). There may be cases where the
selection will adversely affect synchro-
nization. Select the mode after confirming
that the live picture and playback picture
are properly displayed on the monitor.
(L)
UP SIDE DOWN
CHROMA GAIN
AP GAIN
PEDESTAL
HUE
BW
BURST (BW)
CAMERA RESET
RET
To reset to the factory settings
1. Move the cursor to the CAMERA RESET parameter.
PUSH SW is highlighted.
2. While holding down L and M, press I for 2
seconds or more. The camera is reset to the factory
settings.
-41-
** SPECIAL **
OFF
....I....
....I....
....I....
....I....
- +
OFF
ON
PUSH SW
END