Panasonic WV-CL920A Operating Instructions Manual page 37

9. Move the cursor to DWELL TIME, and select a time
with L or M.
When the time specified here elapses after motion
detection, the camera will notify the connected
device of the alarm activation. The default setting is
2S.
Available Time (second): 2 s, 5 s, 10 s, 30 s
Notes:
• Masking or adjusting the detection level is needed
to prevent malfunction under the following condi-
tions:
When shooting an object under flickering fluo-
•
rescent light or shooting in ELC.
When leaves or curtains etc. are swayed by the
•
wind.
When the object is lighted by lighting equip-
•
ment that constantly turns on and off.
• Set MOTION DET to OFF when the camera is
installed in a system other than a Panasonic CCTV.
Otherwise the multiplexed alarm signal may be mis-
understood as a time-code.
• There may be a delay of about 0.2 seconds from
the time of motion detection until the ALARM OUT
terminal becomes active.
9. Lens Drive Signal Selection
(LENS DRIVE)
This item is used to select the type of auto iris lens drive
signal to be supplied to the lens from the auto iris lens
connector.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
LENS DRIVE
END
1. Move the cursor to the LENS DRIVE parameter.
2. Select DC or VIDEO depending on the type of lens
installed. The default setting is DC (HIGH).
DC: Controls the DC-driven type lens.
VIDEO: Controls the video-driven type lens.
-38-
OFF
ALC
OFF
ON(DNR-H)
OFF
INT
ATW1
OFF
DC
SET UP ENABLE