Panasonic WV-CL920A Operating Instructions Manual page 35

• Automatic White Balance Control Mode (AWC)
In this mode, accurate white balance is obtained
within a color temperature range of approximately
2 300-10 000K.
1. Move the cursor to the WHITE BAL parameter and
select AWC PUSH SW.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
LENS DRIVE
END SET UP ENABLE
2. Press I to start the white balance setup. The
PUSH SW is highlighted to indicate that the white
balance is being set.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
LENS DRIVE
END SET UP ENABLE
OFF
ALC
OFF
ON(DNR-H)
OFF
INT
AWC PUSH SW
OFF
DC
OFF
ALC
OFF
ON(DNR-H)
Highlighted
OFF
INT
AWC PUSH SW
OFF
DC
3. When the white balance setting is completed, the
PUSH SW returns to normal display.
Note: In case that the white balance is not set, the
PUSH SW is being highlighted.
4. When you want to adjust the white balance manual-
ly, press M to select AWC and press I. The
AWC menu appears on the monitor. (When ATW is
selected, pressing I displays the ATW menu.)
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL AWC
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
Manual Fine Adjustment for AWC (ATW)
You can set the white balance items manually.
1. To set MASK SET, proceed as described in steps 2
to 4 of "ALC mode with PRESET OFF" (See page 26
and 27).
2. Move the cursor to R.
3. Press L or M to obtain the optimum amount of
red gain.
4. Move the cursor to B.
-36-
** AWC **
R ....I....
- +
B ....I....
- +
MASK SET
RET END