Panasonic WV-CL920A Operating Instructions Manual page 21

• Editing the CAM SET UP Menu
To edit the CAM SET UP menu (change settings), press
J and K or L and M to move the cursor to SET
UP DISABLE in the bottom line.
Press I. SET UP DISABLE changes to SET UP
ENABLE. Move the cursor to END, then to the item(s)
you want to change.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP DISABLE
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
Notes:
• When SET UP DISABLE appears in the bottom line
of the CAM SET UP menu, you cannot change the
currently active settings. This is to prevent acciden-
tal changing of the settings.
• When the setup menu is closed after changing the
parameters in the menu, the new values are saved
in the EEPROM
Programmable Read Only Memory). These values
remain valid until new values are saved, even if the
power of the camera is off.
-22-
(Electric Erasable and