Panasonic WV-CL920A Operating Instructions Manual page 34

• To reset COARSE and FINE to the values pre-
set at the factory, press L and M simultane-
ously. COARSE and FINE adjustments are pre-
set at the factory to zero-crossing of the AC line
phase.
• If the AC line contains noise (spike noise, etc.),
the stability of the vertical phase of the camera
video output signal may be disturbed.
7. White Balance Setting (WHITE BAL)
7-1. Auto-Tracing White Balance Mode (ATW)
You can select one of four modes for white balance
adjustment as follows:
• ATW1 (Auto Tracing White Balance 1)
In this mode, the color temperature is monitored
continuously and thereby white balance is set auto-
matically. The color temperature range for the prop-
er white balance is approximately 2 600 - 6 000K.
Proper white balance may not be obtained under the
following conditions:
1. The color temperature is out of the 2 600 -
6 000K range.
2. When the scene contains mostly high color
temperature objects, such as a blue sky or sun-
set.
3. When the scene is dim.
In these cases, select the AWC mode.
Move the cursor to the WHITE BAL parameter and
select ATW1. The white balance of the camera is
automatically set.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
LENS DRIVE
END
• ATW2 (Auto Tracing White Balance 2)
Auto-tracing white balance of the sodium light
mode (ATW2)
In case that you select ATW2 for sodium light, white
balance is set automatically (Operation is not need-
ed).
Note: ATW1 and ATW2 do not appear for the
WHITE BAL parameter on the system controller
setup menu.
-35-
OFF
ALC
OFF
ON(DNR-H)
OFF
INT
ATW1
OFF
DC
SET UP ENABLE