Panasonic WV-CL920A Operating Instructions Manual page 27

2-3. Compensating Flare Phenomenon (PEAK MODE)
There may be cases where the lens causes the dis-
played picture to sway like a flare especially when a
strong light is input. You can compensate for this unde-
sired effect.
Move the cursor to PEAK MODE, and select ON or OFF.
ON: Compensates flaring of the picture.
OFF: Does not compensate.
3. Shutter Speed Setting (SHUTTER)
Note: When ELC is selected for ALC/ELC on the CAM
SET UP menu, this item is not available.
You can select an electronic shutter speed of 1/60
(OFF), 1/100, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000, or
1/10 000 seconds.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
LENS DRIVE
END SET UP ENABLE
Move the cursor to the SHUTTER parameter and select
the electronic shutter speed.
OFF
ALC
OFF
ON(DNR-H)
OFF
INT
ATW1
OFF
DC
The preset values for SHUTTER (electronic shutter
speed) change by pressing L or M as follows:
OFF (1/60)
1/10 000 1/4 000
4. Gain Control Setting (AGC ON/OFF)
You can select an automatic gain control (AGC) mode
with dynamic noise reduction (DNR) options.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
LENS DRIVE
END
1. Move the cursor to AGC and select a mode.
OFF: Applies neither AGC nor DNR.
ON (DNR-H): Applies AGC with high-level DNR.
ON (DNR-M): Applies AGC with middle-level DNR.
ON (DNR-L): Applies AGC with low-level DNR.
-28-
1/100 1/250 1/500
1/2 000 1/1 000
OFF
ALC
OFF
ON(DNR-H)
OFF
INT
ATW1
OFF
DC
SET UP ENABLE