Changing The Print Settings For The Transaction Report - Sharp DX-2500N Operation Manual

CHANGING THE PRINT SETTINGS FOR THE
TRANSACTION REPORT
(Transaction Report)
A transaction report is automatically printed out to alert you when a transmission fails or when a broadcast transmission
is performed. The transaction report contains a description of the transmission (date, start time, name of other party,
time required, number of pages, result, etc.).
+
INFORMATION APPEARING IN THE RESULT COLUMN
Transaction reports are printed based on conditions set in the system settings; however, you can temporarily select
different conditions for a transmission. To change the transaction report print conditions at the time of transmission,
follow the steps below.
Place the original.
1
Place the original face up in the document feeder tray, or face down on the document glass.
Enter the destination fax number.
2
+
ENTERING DESTINATIONS
Select the special modes.
(1) Touch the [Special Modes] key.
3
(2) Touch the
(3) Touch the [Transaction Report] key.
+
SPECIAL MODES
Fax/Special Modes
Transaction Report
Always Print
Print Original Image
4
• The print conditions for a transaction report are as follows:
"Always Print": A transaction report is printed no matter whether the transmission succeeds or fails.
"Print at Error": A transaction report is printed when transmission fails.
"Do not Print": Do not print a transaction report.
• When the [Print Original Image] checkbox is selected
transaction report.
• Even if the [Print Original Image] checkbox is selected
direct transmission, polling reception, or F-code transmission is used.
(page 4-16)
keys to switch through the screens.
(page 4-71)
(1) (2)
OK
Cancel OK
Print at Error Do not Print
(page 4-133)
Select print conditions.
(1) Select the print conditions.
(2) Touch the [OK] key.
, part of the transmitted original is included on the
, the original cannot be printed when speaker dialling,
4-93
FACSIMILE
Contents