Tray Settings For Tray 3 To 4; (Stand/500&2000 Sheet Paper Drawer) - Sharp DX-2500N Operation Manual

TRAY SETTINGS FOR TRAY 3 TO 4

(Stand/500&2000 Sheet Paper Drawer)
LOADING PAPER IN PAPER TRAY 3 - TRAY 4
A4 or 8-1/2" x 11" size paper can be loaded in tray 3 and tray 4. These are parallel large-capacity trays that allow a total
of approximately 2000 sheets of SHARP standard paper (80 g/m
size of tray 3 or tray 4, see
For information on how to load paper and change the paper size for a single tray, see
TO 4" (page 1-32).
1
2
3
"CHANGING THE PAPER SIZE IN PAPER TRAY 3 - TRAY
Indicator
line
Indicator
line
BEFORE USING THE MACHINE
2
(20lbs.)) to be loaded. If you wish to change the paper
Pull out paper tray 3-tray 4.
Gently pull the tray out until it stops.
Fan the paper.
Fan the paper well before loading it. If the paper is not fanned,
multiple sheets may feed at once and cause a misfeed.
Load paper in the left and right trays.
Lift the paper guide and load paper in tray 3.*
Approximately 1150 sheets of SHARP standard paper
2
(80 g/m (20lbs.)) can be loaded.
Be sure to return the paper guide to its original position after
loading the paper.
Lift the paper guide and load paper in tray 4.*
Approximately 850 sheets of SHARP standard paper
2
(80 g/m (20lbs.)) can be loaded.
*1 The paper stack must not be higher than the indicator line.
1-34
4" on the next page.
"TRAY SETTINGS FOR TRAY 1
1
1
Contents