Re-Registering The Handset - Panasonic KX-TG5480 Operating Instructions Manual

Special Features

Re-registering the Handset

If "No link to base. Move closer to base and try again." is
displayed even when using the handset near the base unit, the handset may have
lost communication with the base unit. You need to re-register the handset to that
base unit.
Make sure the base unit is not being used. Have both the handset and base
unit nearby during registration.
1
Handset: Press [MENU].
2
Handset:
Scroll to
" Initial setting
[d] or [B] hen press the soft key
, t
3
Handset:
Scroll to "Registration" by pressing [d]
or [B] then press the soft key (
,
4
Base unit:
Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds.
• The CHARGE indicator flashes. After the CHARGE indicator starts flashing,
the rest of the procedure must be completed within 1 minute.
5
Handset:
(1) Press the soft key (
(2) Wait until a long beep sounds and the
display shows the following.
• Registration is complete.
• You can stop registration by pressing [OFF] on the handset and pressing
[LOCATOR/INTERCOM/TRANSFER] on the base unit.
64
Handset & Base Unit
by pressing
"
( ).
SELECT
).
SELECT
).
O K
Initial setting
Registration
Press LOCATOR
on base unit
for 3 sec.
Then press OK
O K
BOX 1 BOX 2
SPIPRIVACY1
[2]
IN USE
Handset [1]
Registered