Table of Contents
Advertisement
Display panel adhesive is available as spare part number N12238-001.
11.
To replace the camera module:
a.
Remove the two Phillips M2.0 × 3.0 screws (1) from top bracket, and then remove the bracket from
the display rear cover (2). The bracket is available as spare part number N19715-001.
NOTE:
b.
Use to tool to detach the module (1) from the display back cover. The module is attached to the
display back cover with double-sided adhesive.
c.
Disconnect the cable from the reverse ZIF connector on the camera module (2). Note that the cable
routes underneath the camera module.
The camera module is available as spare part number N20114-001.
12.
To remove the hinges from the display enclosure:
a.
Remove the three Phillips M2.5 × 2.5 screws (1) that secure each hinge to the display back cover.
b.
Remove the hinges (2).
The display hinges are available using spare part number N19719-001.
42
Chapter 5 Removal and replacement procedures for authorized service provider parts
In this procedure, the display assembly will not be connected to the computer.
Advertisement
Table of Contents
