Table of Contents
Advertisement
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
NOTE:
You can remove the bezel, display panel, and camera module without removing the display
assembly from the computer. For more information, see
display) on page
27.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the display assembly:
1.
Lift the plastic from the display connector on the system board (1), and then disconnect the display cable
from the system board ZIF connector (2).
2.
Remove the two Phillips M 2.0 × 2.5 screws (3) from the bracket that covers the connectors, and then
remove the bracket (4).
3.
Disconnect the four wireless antenna cables from the WWAN module integrated into the system board
(5). Note that you need to remove only the far left and third from the left antenna.
4.
Remove the four Phillips M2.5 × 4.0 screws (1) that secure the display assembly to the computer.
5.
Remove the bracket from each hinge (2).
6.
Open the computer to open the hinges to 90° (3).
7.
Remove the antenna cable from the clip in the right hinge cavity (4).
Display subcomponents (without removing the
Preparation for disassembly on page
Bottom cover on page
24).
24).
Battery on page
25).
Display assembly
39
Advertisement
Table of Contents
