Table of Contents
Advertisement
1.
Remove the four Phillips M2.0 × 2.5 screws (1) that secure the touchpad bracket to the computer, and
then remove the bracket (2).
2.
Remove the tape from the connector on the touchpad (1), and then disconnect the touchpad cable (2)
from the touchpad ZIF connector.
3.
Lift the protective Mylar from the screws along the top of the touchpad (3).
4.
Remove the three Phillips M2.0 × 2.5 screws (4) that secure the touchpad to the computer.
5.
Remove the grounding tape from the both sides of the top of the touchpad (5).
6.
Remove the touchpad from the computer (6).
To install the touchpad, reverse this procedure.
32
Chapter 5 Removal and replacement procedures for authorized service provider parts
Advertisement
Table of Contents
