Miele DGC 7150 Operating And Installation Instructions page 97

Problem
Max. op. hours
appears in the
reached
display.
and a fault code
Fault
not listed here appears
in the display.
The Start at and Finish at
functions are not
available.
This function is not available
appears in
at the moment
the display after
selecting the Descale
function.
Programmes that use
added moisture are not
taking in water.
A noise can be heard
after a cooking
programme.
After moving house, the
combination steam
oven no longer
switches from the
heating-up phase to the
cooking phase.
Cause and remedy
The combination steam oven has been operating for
an unusually long time. This has triggered the safety
switch-off function.
 Confirm with OK.
The combination steam oven is now ready to use
again.
A fault has occurred that you cannot resolve.
 Call the Miele Customer Service Department.
The temperature in the oven compartment is too
high, e.g. after a cooking process has finished.
 Open the door and let the oven compartment
cool down.
These functions are not generally available in
maintenance programmes.
The steam injection system is faulty.
 Call the Miele Customer Service Department.
Demo mode is active. You can select menu options
in the display and the sensor controls, but the pump
for the steam injection system is not working.
 Deactivate Demo mode by selecting
Showroom programme
The pump for the steam injection system is faulty.
 Call the Miele Customer Service Department.
The cooling fan remains switched on after a cooking
programme (see "Settings – Cooling fan run-on").
The boiling temperature of the water has changed as
the altitude of the new location for the appliance
differs from the old one by at least 300 m.
 Adapt the boiling temperature to the altitude of the
new location (see "Settings – Altitude").
Problem solving guide
| Demo mode | Off
|
Settings
.
97